RGB stereo sound & light show processor for Hi. The Control Unit case is available in BLACK or LIGHT GRAY. Please tell which color you need when ordering. The default is LIGHT GRAY.
The OLED-display is warm white. Spectrum analyzing of input audio signal and controls LEDs. Each color (red, green, blue) displays the amplitude of a certain audio frequency (bass, mid, treble) from input signal, separately for left and right channels. Digital signal processing, brightness and smoothing control. Bright and high-contrast OLED display.
Suitable for rooms up to 100 sq. Dimensions W x D x H (mm). 225 x 185 x 45. 230 x 70 x 70. STEP 1: Connect audio source to the Control unit.There are 2 ways to connect audio source to CM-3S. A Connection via LINE IN (2xRCA - recommended).
B Connection directly FROM SPEAKERS (differential input). Do not use both of those types at the same time. For example, if you use AV-receiver as source, you may connect recorder output terminal of receiver to "LINE" terminal of CM-3S via 2RCA-2RCA cable.
Else if there is no line outputs in your audio system, you may simple connect speaker terminal of your amplifier to hi-level "FROM SPEAKERS" terminal of CM-3S via speaker wire. STEP 2: Connect left and right LED units to the Control unit. STEP 3: Connect Power supply to the Control unit.
Controls (see video for more details). Press STANDBY/ON to turn power on or turn power off. Turn SELECT/MENU knob to enter menu and choose parameter. Turn BRIGHTNESS/SET knob to change current value. Press MODE/OK to exit menu or enter sub-menu, or to enter Strobe mode (see below).Turn the SET knob to increase/decrease common brightness of all LEDs proportionally. You also may control common brightness by turning the SET knob in main screen. Turn the SET knob to increase/decrease brightness of RED LEDs. Turn the SET knob to increase/decrease brightness of GREEN LEDs. Turn the SET knob to increase/decrease brightness of BLUE LEDs.
SMOOTHING (only in general mode). Turn the SET knob to increase/decrease smoothing. It will effect on different musical styles.ADVANCED (only in general mode). Press OK to enter sub-menu. Turn the SET knob to increase/decrease limit of auto balancing between red, green and blue LEDs. Lower value will give a more faithful representation of the frequency response. Higher value will give a better alignment between the amplitudes of the different frequencies (colors). Turn the SET knob to increase/decrease limit of input sensitivity. When amplitude of input signal is changing the CM-3S will automatically increase or decrease sensitivity in wide range.
So if you have dirty input signal with noise, it may be cause of undesired LEDs glowing during the pause between musical tracks. In this case try to decrease limit of input sensitivity. Remember, that too small value of this parameter may lead to insufficient sensitivity of the CM-3S in quiet music compositions.
Turn the SET knob to select frequency range. Select WIDE for high quality input signal, or select AUTO or NARROW for low quality input signal. Turn the SET knob to select YES or NO.
Press OK again to confirm selection. If selected YES all settings will be reset to factory defaults. Press OK to exit sub-menu. Press OK to exit menu. Press MODE in the main screen to enter/exit the stroboscope mode.
In the STROBE mode LEDs are independent from the input signal. You may control brightness, frequency and duty factor of strobes via menu.
STROBE FREQUENCY (only in STROBE mode). Turn the SET knob to increase/decrease strobe frequency.STROBE DUTY FACTOR (only in STROBE mode). Turn the SET knob to increase/decrease strobe duty cycle. The item "DIKAPO CM-3S Sound Light Show Hi-Fi RGB LED Party Lights Music Spectrum Analyzer" is in sale since Tuesday, January 2, 2018. This item is in the category "Consumer Electronics\TV, Video & Home Audio\Home Audio\Home Audio Components\Other Home Stereo Components".
The seller is "payalnik85-ru" and is located in Kazan, Tatarstan. This item can be shipped worldwide.